- This topic has 3 replies, 3 voices, and was last updated 14 years, 10 months ago by
.
-
Posts
-
Went out to this machine tonight and replaced Detergent Hose, Motor, & PCB since the detergent hose was leaking all over the motor, the motor was covered in rust, and the machine had died (no power).
After replacing the parts I tested the machine and all was fine so I put the machine on a spin test… again, all fine.. water test, all fine, so I had the customer sign off the sheet and I went on my merry way to my next job.
10 mins ago I got a call off this customer; she said that she put the machine on a full wash and it was great… lovely and quiet and went through the wash completely with no problems at all… She put in her second wash and shut the door, she pressed start and the door locked… after 1 or 2 seconds the machine went off again… dead again (no power) then the door lock opened.
To me it sounds like door lock or water solenoid, but door lock works and she had just done a full wash…
Any ideas?George
Re: Amica AWCT10L Power Loss
Hi George
Did you glue up the small grey breather hose on the back of dispenser when you replaced dispenser hose?
They leak from here and run down drum on to motor?
So may well have damage board again.
HTH
Steven
Re: Amica AWCT10L Power Loss
Went back to this yesterday… changed the door lock & PCB… No further calls from the woman, as of yet… Obviously intermittant door lock problem.
Steven… Thanks for the tip… I also glued that pipe for future safety.
George
- You must be logged in to reply to this topic.