Zanussi zwf1437w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi zwf1437w

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • June 17, 2011 at 7:53 am #63424
    DDDave
    Participant

    Carbon brushs were gone on this machine. I replaced them and now customer says the machine goes through was but stops with 1 minute left. I ran it through test and it gave E35- tacko. Is this likely to be the fault as the machine washs and spins when I test it ??

    June 17, 2011 at 3:00 pm #353730
    maltheviking
    Participant

    Re: Zanussi zwf1437w

    E35 = Overflow on this model
    Faults for E35
    Water fill solenoid valve is defective; Leaks from water circuit on
    pressure switch; Pressure switch defective; Wiring defective; Main
    board defective. 😕


    Cycle stops. Emergency drain
    procedure. Drain pump continues to
    operate (5 min. on, then 5 min. off,
    etc.).

    June 17, 2011 at 8:03 pm #353731
    DDDave
    Participant

    Re: Zanussi zwf1437w

    I dont know how I screwed up there :boops: . Thanks for the help. :tup:

    June 17, 2011 at 9:10 pm #353732
    maltheviking
    Participant

    Re: Zanussi zwf1437w

    DDDave wrote:I dont know how I screwed up there :boops: . Thanks for the help. :tup:

    It will be the Guiness, either to much or to little :mrgreen:

    June 17, 2011 at 10:59 pm #353733
    DDDave
    Participant

    Re: Zanussi zwf1437w

    Is there ever too much ??

    June 18, 2011 at 8:20 am #353734
    Martin
    Participant

    Re: Zanussi zwf1437w

    maltheviking wrote:Faults for E35

    You missed out duff heater Mal. 😉

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.