Hoover 3761 Automatic

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover 3761 Automatic

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 24, 2004 at 5:44 pm #6351
    Matilda
    Participant

    Second opinion please – Just been out to this one for a mate on holiday. The fault is, it will not spin but will distribute at start of spin program 7. Mate repaired speed control module some weeks ago (burnt track) which is still ok. Module Remco 5038. Any advice much appreciated – Mat.

    September 24, 2004 at 5:46 pm #117163
    Penguin45
    Participant

    99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} module, 1{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} p/switch problems!

    Chris.

    September 24, 2004 at 6:45 pm #117164
    cornwell40
    Participant

    Re: Hoover 3761 Automatic

    Had a good few of these modules failed recently. Usually relay or dry joint related.

    Tony C

    September 25, 2004 at 6:41 am #117165
    Simon46
    Participant

    Re: Hoover 3761 Automatic

    I find that if the relay contacts start arcing internally and get hot pin desolders itself from board. Only guaranteed cure is replacement module.

    September 25, 2004 at 1:46 pm #117166
    Matilda
    Participant

    Re: Hoover 3761 Automatic

    Thanks all I’ll check the p/s and then view a qer/emw module – Mat.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.