BEKO WMA667

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › BEKO WMA667

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • July 4, 2011 at 7:57 pm #63746
    gadgetdad
    Participant

    Hi guys, received a call late tonight and going to see this in the morning.

    18months – 2 years old machine seems to work fine but does not do final spin. Apparantly goes into spin for about 10 secs then stops.

    I would say brushes of course but at this age ??

    Anyone had this error before.

    cheers

    gadge

    July 4, 2011 at 10:53 pm #354733
    leavemetogetonwithit
    Participant

    Re: BEKO WMA667

    gadgetdad wrote:Apparantly goes into spin for about 10 secs then stops.


    Probably trying to spin whilst full of water. Has customer checked filter? If you need the work, get there quick before they do!
    Mike.

    July 4, 2011 at 11:06 pm #354734
    gadgetdad
    Participant

    Re: BEKO WMA667

    Had them run a drain cycle while I was on the phone – drained no problem.

    July 4, 2011 at 11:17 pm #354735
    leavemetogetonwithit
    Participant

    Re: BEKO WMA667

    Boards do odd stuff on these but at least they’re usually not too dear. But would first check tacho and its magnet. Could even be a kaput armature.
    Mike.

    July 5, 2011 at 10:18 am #354736
    gadgetdad
    Participant

    Re: BEKO WMA667

    Thanks guys.

    Just popped in to this machine – put it on spin and it fires up for about 20 secs then stops and so does the drain pump – board problem do you think ? Washes and drains fine.

    gadge

    July 5, 2011 at 10:30 am #354737
    DDSDDS
    Participant

    Re: BEKO WMA667

    tacho magnet broke

    July 5, 2011 at 10:52 am #354738
    gadgetdad
    Participant

    Re: BEKO WMA667

    Is that a defo – just about to order board. Machine is in a cupboard so couldnt get it out to get under it !

    July 7, 2011 at 12:07 pm #354739
    DDSDDS
    Participant

    Re: BEKO WMA667

    seen a few beko magnets cracked in half on these
    its quite common and as far as i know they come complete with the motor
    i would be having the motor off before ordering anything

    July 7, 2011 at 6:18 pm #354740
    Criscold
    Participant

    Re: BEKO WMA667

    Have you got into diagnostics on this?

    July 7, 2011 at 9:45 pm #354741
    gadgetdad
    Participant

    Re: BEKO WMA667

    Guys, replaced module and off it went – all good.

    How do I get into diags – for future info ?

    gadge

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.