Diplomat/Wpool ADP8322 Dish Washer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Diplomat/Wpool ADP8322 Dish Washer

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 18, 2011 at 8:10 am #63981
    Auldyn
    Participant

    Cant seem to find info on this fault this one has a pressure switch not a flowmeter: switch on to any program, shut door, drain pump starts then stops but will not fill then constant bleeps.
    No leaks, inlet solenoide OK no power to solenoide, heater OK.

    any clues?

    Paul

    Auldyn Electrics

    July 18, 2011 at 9:21 am #355730
    electrofix
    Moderator

    Re: Diplomat/Wpool ADP8322 Dish Washer

    count the number of flashes light on front panel ( from 1 to 15 flashes )

    no of flashes = fault code
    code in stickies at top of forum

    Dave

    July 20, 2011 at 10:22 am #355731
    Auldyn
    Participant

    Re: Diplomat/Wpool ADP8322 Dish Washer

    Been back to this one today, Bleeps when door is shut and led next to the start button flashes continuously on any program drain pump runs for about 30secs then stops but it still bleeps and flashes all the time.

    Can’t seem to enter diagnostics mode it still continues through the same cycle as above.

    scratching my head on this one!

    any more ideas

    Paul
    Auldyn Electrics

    July 20, 2011 at 10:54 am #355732
    electrofix
    Moderator

    Re: Diplomat/Wpool ADP8322 Dish Washer

    the only fault code that can look like this is 1. 1 flash then a space then 1 flash etc

    this is NTC but if its not its the pcb i noramlly keep a test ntc to try this

    just measure my test one at room temp today and getting 55K ohms

    buy a similar resistor disconnect ntc and replace with resistor and see if fault stops. obviously you cant run it for long it will overheat but its a cheap test

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.