Bosch SMS63E09GB/02 e15/e16

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch SMS63E09GB/02 e15/e16

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 20, 2011 at 9:54 am #65163
    wizard
    Participant

    Hi. Called out to the above machine last week with customer complaining of ‘check water’ led on. Checked inlet, outlet and cleaned filters/ turbidity sensor and ran through a couple of fill sequences – all ok. Got called back as it has now shown e16 (inlet valve) then e15 (water in base). Dried out base and switched on, inlet valve runs constantly until it floods into base and controls completely unresponsive to reset or any other change even before it shows a fault.
    Anybody got any ideas, I can only suspect main pcb has a fault caused by some other component, although no marks on board.
    Thanks in advance, Wiz. 😕

    September 20, 2011 at 10:22 am #359339
    Martin
    Participant

    Re: Bosch SMS63E09GB/02 e15/e16

    Best to try replacing the flow sensor first I would think.

    Part no: 611317

    September 20, 2011 at 6:50 pm #359340
    wizard
    Participant

    Re: Bosch SMS63E09GB/02 e15/e16

    Thanks Martin, but had one on the van so already tried that. Wiz.

    September 20, 2011 at 7:12 pm #359341
    Martin
    Participant

    Re: Bosch SMS63E09GB/02 e15/e16

    :hmm: Looking at the power board there are 5 triacs in a row. It’s my guess that no.5 (marked TH402) has blown?

    September 21, 2011 at 12:00 pm #359342
    wizard
    Participant

    Re: Bosch SMS63E09GB/02 e15/e16

    Thanks Martin, I’ll have another look at the board. Didn’t see anything obvious when I looked before. Wiz

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.