Hotpoint WMA60P

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMA60P

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 20, 2004 at 11:15 am #6565
    Toni
    Participant

    The problem with the above machine is that you can set the programe ok, but when you press start it pauses for about 1 min then switches off & end is displayed on the panel
    I have checked heater for earthing etc, but all is ok

    Any help would be welcome

    Regards

    Toni Paz

    October 20, 2004 at 12:12 pm #118362
    Martin
    Participant

    Re: Hotpoint WMA60P

    Toni,

    When a programme is selected and you press the start button, the first thing the machine should do is PUMP. It is normally energised for 5 seconds and then the machine should fill. Do check the pump out, it may be your trouble and the micro processor is going into error mode as a result. 😉

    You can also perform a ‘Last Error Detected’ interrogation on those machines but that takes some explaining really and possibly I could help you on that if your stuck 🙂

    Best of luck

    Martin

    October 21, 2004 at 3:09 pm #118363
    Toni
    Participant

    Re: Hotpoint WMA60P

    Thanks Martin
    I have arranged to call tomorrow to sort this out (I hope)
    Will post outcome

    Regards
    Toni

    October 28, 2004 at 4:31 pm #118364
    Toni
    Participant

    Re: Hotpoint WMA60P

    After all that, the customer has decided to buy a new machine.
    Luckely she has bought one from me 😀

    Thanks anyway

    Toni

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.