- This topic has 3 replies, 2 voices, and was last updated 14 years, 5 months ago by
.
-
Posts
-
AEG FAVORIT89020VI PNC911938610 SN90870008
This machine is stopping and draining during a wash cycle and displaying service code i60 which i am led to believe is an overheat fault. Water is pumping around ok so i’m thinking it is the ntc sensor. Apparently it can be PC board for this fault too.
Anyone had this fault before and cured it?Thanks
Subs
Ps I replaced the fan, motor and vent system at the top of machine a couple of months ago as condensation had corroded the little crochet motor and was tripping the rcd.Re: AEG Dishwasher error i60
There are two different faults for I60
overheating – The cycle stops and the drain
pump switches on.
Heating element faulty; Safety thermostats (open);
Wiring faulty; NTC-sensor (thermal contact faulty);
Scarce circulation of water in the tub; Wash pump
faulty (damaged impeller) Main electronic board
faultyHeating Time-out
(the check takes place every 3 minutes:
the temperature must increase by a
certain amount at each step) – The programme continues to the
end without heating (the washing
result will probably be
unsatisfactory
Heating element faulty; intervention of safety
thermostats (open); wiring faulty; NTC sensor (poor
thermal contact); insufficient water circulating in the
tub; washing pump faulty (impeller stripped); circuit
board faulty.Re: AEG Dishwasher error i60
Replaced the ntc on this but customer says it is still throwing up error mid cycle and then draining. It is heating. Apparently its not doing it on the cooler washes ie 55 degrees.
Any thoughts on this please?Subs
- You must be logged in to reply to this topic.