Bosch Loggix WIS24140GB/18

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch Loggix WIS24140GB/18

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 1, 2011 at 11:42 pm #66014
    reaper
    Participant

    Built in Loggix needing a new door seal.Tried to remove the front panel in the usual Bosch way ie 2 screws at the bottom and the one near the soap drawer but the panel seems to still be stuck at the top.Not obvious if and how the fascia comes off.any info will be welcome.

    November 2, 2011 at 9:16 am #362736
    Martin
    Participant

    Re: Bosch Loggix WIS24140GB/18

    reaper wrote:Not obvious if and how the fascia comes off.

    With the soap drawer out, remove the small plastic cover that is hiding the 2 screws holding the fascia on left of the dispenser cavity. (Its a push fit so no force reqd).

    The fascia panel is also held on the right hand side by a plastic sprung loaded latch. Access via removing the lid (or if you don’t want to pull the beast out but can turn off the power first of course :wink:)Having unclipped the door seal from the front panel first, reach up on the inside to release said latch with your finger.

    You can now remove the control panel complete and disconnect the plug-in connectors. That just leaves 3 screws holding the front panel at the top. BINGO, your in…..!!! 😀

    November 2, 2011 at 9:17 pm #362737
    reaper
    Participant

    Re: Bosch Loggix WIS24140GB/18

    Thanks Martin – all done and dusted.Just to say that the small plastic cover slides upwards and you have to pull the washer out about 3 inches to get the middle screw on the front panel out with a torx screwdriver.Its so easy when you know how.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.