- This topic has 7 replies, 4 voices, and was last updated 14 years, 4 months ago by
.
-
Posts
-
This is a zan/elux washer dryer: I set program to a wash cycle, the pump runs cont, the timer counts down but wont fill with water.
any advise please. johnRe: JLWD1404 (washer dryer)
This has been discussed quite a few times here in the past couple of years. But finding those discussions is proving difficult. Relying therefore on my colander of a memory, I think this is probably pressure switch related. Hmm something coming back now about sump blockages – colourcatchers that sort of thing, not interfering with drainage so much but flapping about and causing p/switches to give conflicting signals. I’d try disconnecting p/sw hoses, having a feel around sump hose – could even be that damn’ table tennis ball stuck, blocked drain hose end, or p/sw (probably the anal-logic one – see if I’m allowed to say that) itself. Try giving it a gentle tap – disconnect and reconnect etc. May even be loom fault.
HTH, Mike.JLWD1404 (washer dryer)
Bear in mind the if the insulation is below 7Mohm (@500v) through the dryer heaters, wash heater or motor – this can present random errors!
Re: JLWD1404 (washer dryer)
Firestarter, where did you get that figure from? I have had machines show faults at 30Meg and Zanussi manuals I have read state 40.
Mike.
- You must be logged in to reply to this topic.