- This topic has 4 replies, 3 voices, and was last updated 14 years, 3 months ago by
.
-
Posts
-
hi guys never come across one of these , big round twin element dryer , power going to one side of element , heats ok , tested element for continuity and all the tags have readings between each other , how can this be , i removed the wire connectors before testing , also there is a square white block on the back of the element housing with wires in and out to the element , a thermostat ? no power going to this either , also there is power coming from the timer but it never makes it to the end of the wire connected to this one is going to the element also , anyone have info on these thx
Re: hoover SV23 001 low heat
slyp98 wrote:also there is a square white block on the back of the element housing with wires in and out to the element , a thermostat ?
Thats the overheat stat I think and the only other stat I see from the drawing is the exhaust stat. Could the fault be something to do with the low/high heat switch on the control panel?
No technical info available on these as far as I can make out. 🙁
Re: hoover SV23 001 low heat
poss Martin , i didnt take it out or check it for operation but there was power going to it i dont remember how many wires were going to it , i guess it just sends the power in both directions to heat both parts of the element when on high , could be that i spose , cheers i will check
Re: hoover SV23 001 low heat
checked switch its working fine i dont understand how the element has continuity between both parts of it , there are 2 seperate rings 4 tags like a grill element !
- You must be logged in to reply to this topic.