AEG oko lavamat washer, error F9

Home Forums Public Support Forums Help And Support Washing Machine Help Forum AEG oko lavamat washer, error F9

Viewing 13 posts - 1 through 13 (of 13 total)
  • Author
    Posts
  • #6692
    admin
    Keymaster

    Washer has stopped midway through cycle, F9 in display, quick wash on solid, 1500 and 900 flashing. End flashing and over dosing on solid. Can anyone point me towards the area of the fault?

    #119074
    Martin
    Participant

    Re: AEG oko lavamat washer, error F9

    Pump blockage I expect Alex, but the full model number AND the 9 digit PNC number would help 😉 ❓

    Martin

    #119075
    admin
    Keymaster

    Martin, thanks for the prompt response. I have found the answer and the problem. The F9 code refers to MOTOR or MOTOR TACHO FAILURE, usually brushes and in my case it was.
    For reference to clear the error: whilst holding the pre wash and the short wash buttons in together turn the control knob from off to gentle spin, the clears the error and runs a LED test.
    Again, many thans, much appreciated.

    #119076
    admin
    Keymaster

    Re: AEG oko lavamat washer, error F9

    This sorted me out too – Thanks!

    I have an OKO-LAVAMAT 87620 and it was a C9 error. Set dial to off, held Start button in and turned dial to Gentle Rinse.

    #119077
    admin
    Keymaster

    Re: AEG oko lavamat washer, error F9

    I have exactly the same problem (F9 and same cobination of lights) as Alex with my Lavamat 6955 (Also noticed same post on another forum! 🙂

    I can’t for the life of me get the machine to reset and door open to get clothes out following Alex’s instructions.
    Can anyone help? Wife and 3 kids think it is a conspiracy as the service people are taking a week to turn up.

    Also is it possible to see if the brushes are worn – by a layman – and be replaced?

    #119078
    Martin
    Participant

    Re: AEG oko lavamat washer, error F9

    MIchael G wrote:Also is it possible to see if the brushes are worn – by a layman – and be replaced?

    Michael,

    Your machines problem is indeed the motor, usually the motor brushes. A simple and relatively inexpensive job for an expert to undertake for you. 😉

    Can I advise you therefore check our “Directories” listing for an approved repairer. Just type in your Postcode 🙂

    Martin

    #119079
    admin
    Keymaster

    Re: AEG oko lavamat washer 6955, error F9

    Martin,
    Thanks very mush for your quick post.
    It took the motor off a moment ago and removed the brushes – surprisingly easy as you say.
    Certainly one of the brushes appears to have very little left. The other appears to have a little spring in it so I guess some left.
    I have an engineer coming on Wed but was hoping to get it fixed more quickly.
    Still……
    Am I able to get a sameday delivery of these brushes from anywhere and therefore fix it on Monday?

    And most importantly…………how can I open the door? I have tried turning the switch to gentle rinse while holding the quick wash and pre-wash buttons but with no joy. Any help before the mould starts growing on the babies clothes?

    Thanks very much

    #119080
    Martin
    Participant

    Re: AEG oko lavamat washer 6955, error F9

    Michael G wrote:And most importantly…………how can I open the door?

    Simple 😀

    On the bottom left hand side there is a white plastic slotted cap near the pump filter. Simply twist that with a 5p coin (clockwise if I remember right) and the door will fly open…..

    … (plus 3 gallons of water and romper suits if you don’t watch out! :rotfl: )

    Martin

    #119081
    admin
    Keymaster

    Re: AEG oko lavamat washer, error F9

    Martin,
    Thanks very much again.
    Simple! definitely! Even for a newbie like me ❗

    No worries with the water….. it had already emptied.
    Just very smelly….. 😥

    Just my final question……….
    I looked in the shop on this website and it doesn’t have any brushes for AEG.
    Am I really unlikely to get new ones from any where quickly?
    The only place I have found is Domestic Appliances.co.uk.
    http://www.domestic.co.uk/spares/020404 … 40417.html
    However I can’t tell which of the brushes is the right one.
    Clues gratefully received…..

    Thanks
    P.S. Looks like you’ve spent a lot of time, money and energy on the radio gear 😀

    #119082
    Dave_Conway
    Participant

    Re: AEG oko lavamat washer, error F9

    Carbon brushes are not easy to identify these days Michael as manufacturers use a wide variety of motors, even on the same model.

    There’s a pretty good chance the brushes you need are there in the shop but it’s a matter of identifying the correct one’s

    Can you email me a photo of them (in the plastic/bakelite holders) I should be able to tell which one’s you need then 😀

    Dave.

    #119083
    admin
    Keymaster

    Re: AEG oko lavamat washer, error F9

    Thanks for your reply Dave.
    I actually tried to track down the part in my local area but have run out of time. I was told AEG don’t list brushes as a separate orderable item for my serial number machine – 605.649 123
    By the time I’d have got around to taking the photo and uploading I’d have lost more time so……..

    The engineer is here today. I’ll see how it goes. Rumour has it they may insist I change the whole motor – if so I’ll be back following up your request, thanks!

    #119084
    Behari
    Participant

    Re: AEG oko lavamat washer, error F9

    HI there, my machine is displayin F9 code, i replaced the brushes but it still displays the same code, what do u recommend i do,

    #119085
    Dave_Conway
    Participant

    Re: AEG oko lavamat washer, error F9

    Behari wrote:what do u recommend i do,

    Call an engineer to check the other possibilities 😀

    Have a look in the directories or pop up your postcode, there’s probably someone here who can assist.

    Dave.

Viewing 13 posts - 1 through 13 (of 13 total)
  • You must be logged in to reply to this topic.