neff S4453n0gb/13

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › neff S4453n0gb/13

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 20, 2011 at 2:03 pm #66982
    clockworkone
    Participant

    what kind of a job is it to fit heater(491755) on this one.not seen it yet but fault reported is m/c wont stop until you switch it off.

    December 20, 2011 at 3:28 pm #365817
    spimps
    Participant

    Re: neff S4453n0gb/13

    Busy 90 minutes or so depending on if its built in,wash chamber has to be split from the plastis base,not the easiest but OK to do.

    December 20, 2011 at 6:05 pm #365818
    clockworkone
    Participant

    Re: neff S4453n0gb/13

    many thanks for reply.paul

    December 20, 2011 at 6:43 pm #365819
    leavemetogetonwithit
    Participant

    Re: neff S4453n0gb/13

    Read Martin’s opening post in, “Tips, Tricks and Shortcuts.”
    Mike.

    December 21, 2011 at 4:30 pm #365820
    spimps
    Participant

    Re: neff S4453n0gb/13

    Doesn’t get any better than Martins post,spot on.

    December 21, 2011 at 7:24 pm #365821
    nomadPaul
    Participant

    Re: neff S4453n0gb/13

    A faulty / open circuit heater is NOT the most common cause of no heating…..low water levels are . Check the pressure chamber/fill hose first .

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.