re lg direct drive washing machine,

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › re lg direct drive washing machine,

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 1, 2012 at 5:48 pm #67114
    billtec
    Participant

    hi have a lg wm14316fd direct drive ,on its final spin everything shut down,all lights etc,checked fuse in plug ok,so took back off ,all wireing checked ok,found module board,it had a fuse on it,was covered in a gell,cleaned off the ends ,and tested it,had blown,had some glass fuses ,as i repair tvs,and piggy backed solderd one on it.switched on machine ,but it blew fuse sraight away,any help why this happening please,as was a great machine before this thanks.

    January 1, 2012 at 7:43 pm #366373
    paulpaddison
    Participant

    Re: re lg direct drive washing machine,

    fixed a lg a while back similar fault. turned out the diode rectifier on the pcb had gone short once replaced and new fuse fitted it was ok.

    January 1, 2012 at 8:35 pm #366374
    billtec
    Participant

    Re: re lg direct drive washing machine,

    HI,THANKS FOR THAT,DID YOU HAVE TO DIG IT OUT OF THAT 4MM OF GEL STUFF!!.

    January 1, 2012 at 9:21 pm #366375
    admin
    Keymaster

    re lg direct drive washing machine,

    Hi

    Place pcb in a shallow saucepan of boiling water and simmer away and that will melt the gel.

    Bryan

    January 1, 2012 at 9:27 pm #366376
    paulpaddison
    Participant

    Re: re lg direct drive washing machine,

    yeah we dug drilled we tried everything then solderd new one into place 🙂 had a few machines like this with same problem in the past but ran out of spare pcb’s

    January 1, 2012 at 10:25 pm #366377
    billtec
    Participant

    Re: re lg direct drive washing machine,

    re pcb board,have any of you ,got a good used board for this lg model,thanks

    January 1, 2012 at 11:24 pm #366378
    paulpaddison
    Participant

    Re: re lg direct drive washing machine,

    i will have a look for you later in the week when i get back to the workshop fingers crossed

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.