- This topic has 7 replies, 4 voices, and was last updated 14 years, 2 months ago by
.
-
Posts
-
hi guys had a look at this today its had little use ,customer sayes it stops mid cycle and when i checked it , no heat from the element , it checks out ok though 23 ohms , theres a stat or toc next to it and there is cont, there too power going to the element when in use also ? so i dunno i’m gonna replace the element anyways anyone had this kind of fault b4 cheers
Re: zanussi DW908 stops mid cycle
Doesn’t this machine have a timer? Worth checking the wiring loom inside the door. If that’s ok, then considering what you’ve checked already, could be the timer.
Re: zanussi DW908 stops mid cycle
Would it “stop” (= no sloshing?) just because it wasn’t heating?
I doubt it. Perhaps it’s not reaching the heating period before stopping.
Mike.Re: zanussi DW908 stops mid cycle
i have to refer back to the original post , the problem being it has 220v going to the element but its cold , i cant see how this problem is something to do with the pcb , it has power at the element terminals , i didnt measure amperage but surely that wouldnt matter it has 220v !has to be carrying current also right ?
Re: zanussi DW908 stops mid cycle
slyp98 wrote:there too power going to the element when in use also ?
Sorry, I interpreted that as meaning you had an indication with e.g. a “voltstick”, rather than your multimeter connected across the element. The control from pcb is usually in the neutral side.
Mike.
- You must be logged in to reply to this topic.