Bosch WFL2463GB/12

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WFL2463GB/12

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 15, 2012 at 4:09 pm #67919
    Bryan
    Participant

    Water not heating but progresses through cycle as normal.
    Element ok, PCB visually intact and wiring from element back to pcb and presure switch ok.
    From quick search I believe this my be a NTC fault, it’s reading 8k ohms, is this within range please?

    Thanks

    Bryan

    February 15, 2012 at 4:25 pm #369028
    Martin
    Participant

    Re: Bosch WFL2463GB/12

    8.5 – 10.6 @ 10degs
    5.4 – 6.5 @ 20degs
    3.5-4.3 @ 30degs

    HTH Bryan? 😀

    February 15, 2012 at 4:35 pm #369029
    Bryan
    Participant

    Re: Bosch WFL2463GB/12

    Yes, thanks Martin.
    NTC seems to be reading about right then ❓ 😕

    February 15, 2012 at 5:05 pm #369030
    Martin
    Participant

    Re: Bosch WFL2463GB/12

    If it were a heating type fault then the programme would take at least an hour or even more longer to complete any cycle. But you say it “progressess through as normal” which is rather odd to say the least. 😕

    If it does in fact take a lot longer than normal yet the heater checks out OK then it’s got to be the PCB. NTC’s don’t usually give this fault, in fact they rarely fail as a rule.

    All the best!

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.