Wma 32 will not spin at full speed

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Wma 32 will not spin at full speed

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 29, 2012 at 8:49 pm #68191
    AASWALES
    Participant

    Hi this hotpoint wma32 will not spin at full speed it tumbles ok then starts to work up speed and starts pulsing then stops and tumbles again? I had this machine in for bearings and noticed the fault on test after fitting the bearings , customer said it was spinning fine before ?

    Any ideas

    Cheers Alan

    February 29, 2012 at 9:14 pm #370146
    jimca007
    Participant

    Re: Wma 32 will not spin at full speed

    This is quite an early one they were really prone to motor loom problems as it rubbed on the front weight might be an idea to run your fingers over the loom wires individually see if you can find a ” lump ” this is likely to be an internal break. Motor start to ramp up, you get a bit wobble, wire disconnects internally and the cycle repeats…

    February 29, 2012 at 9:26 pm #370147
    Allsorts
    Participant

    Re: Wma 32 will not spin at full speed

    Motor loom or Tacho fault .. Had that wit a tacho fault on a few occasions.

    George

    February 29, 2012 at 9:36 pm #370148
    AASWALES
    Participant

    Re: Wma 32 will not spin at full speed

    Thanks for the reply’s I will take a look tomorrow
    Alan

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.