HNWL6136 Hoover washer dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HNWL6136 Hoover washer dryer

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 5, 2012 at 10:19 pm #68284
    robedoo
    Participant

    went too this one recently and fitted new mudule, customer called me back today motor is now not controlling speed have checked the tacho and it seems fine anyone had this or similar?

    March 5, 2012 at 10:36 pm #370456
    jimca007
    Participant

    Re: HNWL6136 Hoover washer dryer

    hate to say it but sounds like a shorted triac on the pcb. Was the motor a bit ropey before you changed the PCB? it it was a bit arc-y before which may have caused the original PCB to go then although you’ve cured the ” fault ” being the PCB you may have missed the cause and it’s done it again. If its any consolation I’ve replaced the triac on this boards quite a few times without any grief and they’re only about £ 3 from RS

    March 6, 2012 at 12:58 pm #370457
    jrrepair_2000
    Participant

    Re: HNWL6136 Hoover washer dryer

    I have had the Magnet come loose on the end of the motor rotor. Screw back on & tighten.

    March 6, 2012 at 2:26 pm #370458
    Martin
    Participant

    Re: HNWL6136 Hoover washer dryer

    …..yep, agreed!….usually the magnet comes loose. Refit with a bit of Loctite on the threads. 😉

    March 7, 2012 at 8:40 am #370459
    robedoo
    Participant

    Re: HNWL6136 Hoover washer dryer

    thanx gents appreciate your time. Rob

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.