- This topic has 3 replies, 2 voices, and was last updated 14 years ago by
.
-
Posts
-
Hi all,
beko wma 641wI have been given this machine as my old one finally gave up.
This machine was purchased new a few years ago put in my brother in laws flat and was never used (he gave his washing back to his mother to do) consequently I’ve now got it fitted it and it wont complete any program cycle, it fills drum turns once or twice then empties, if put on spin only drain pump spins drum turns once repeats twice then ends.I followed this
http://www.ukwhitegoods.co.uk/help/fix- … codes.html
and got code 6 Motor triac open circuit please can someone explain this or better tell me how to fix it.
Many thanks in advance of any repliesRe: beko fault code 6 any info please
The taco is the wee coil on the rear of the motor, a magnet attached to the motor shaft turns within the coil generating a small current, the faster it turns the higher the output this tells the machine how fast the motors turning.In your case this code would suggest the motor brushes are very low so the motor doesnt turn hence no generated current or alternatively there’s a wire broken on the motor plug. Unplug supply tilt the machine back to 45 degrees making sure it rests securely against a wall, then from underneath you can see the two black brush holders on the motor held on with two chrome star head screws remove one of the brushes and if the length is less than about half inch long you need to replace both. If not check the motor plug for broken wires giving each a GENTLE tug in turn to ensure none are broken.
Re: beko fault code 6 any info please
Thanks jimca007 you nailed it :worthy: :tup:
It was a lose wire on motor I must have knocked it whilst moving it, by using a sack truck :boops:
- You must be logged in to reply to this topic.