- This topic has 14 replies, 3 voices, and was last updated 14 years ago by
.
-
Posts
-
have a prob with this one i see other posts but no answers to it , will start but only runs for 2 mins , this decreases the more it is restarted , it ran for 2 mins until i put a damo towel in and straight away went down to 20 seconds anyone have info on this model thanx happy chocolate bunnies
Re: beko dcrs 68 stopping
If you leave it for a few minutes does it then start again tumbling in the same direction?
Re: beko dcrs 68 stopping
Then your pcb needs changing or repairing. You have a relay and/or capacitor gone on the board.
Re: beko dcrs 68 stopping
check element and sensor inside door?there is a test program on here somewhere
Re: beko dcrs 68 stopping
test program runs fine tumbles both ways not in the order specified though it tumbles clockwise fist then anticlockwise , heats, and the sensor has power to it ?
Re: beko dcrs 68 stopping
did all or half the element come on?if it all came on then i would be looking at the module
Re: beko dcrs 68 stopping
originally when i removed the back cover half of it came on then later all of it was on , all i can say for definite is that it was not very hot in there when i was going through the test program
Re: beko dcrs 68 stopping
if you have a clamp meter you can how much current it is using
in test mode against the element rating.other than that module i would think.maybe ewm miight be able to test it for you and supply one if it is gone.Re: beko dcrs 68 stopping
cheers fella ,i just dont understand how it tumbles both ways in test mode ? is it not using the same relay , caps ,doides etc in normal op ? is it because its isolating the operations seperate parts of the program ? yeah i might try emw depending on the price of a new board thanks
- You must be logged in to reply to this topic.