- This topic has 6 replies, 6 voices, and was last updated 13 years, 11 months ago by
.
-
Posts
-
Hi I have a Bosch in for a bearing change and the tub is held together with about 6 screws and about 30 plastic wedge clips , is there a better way to undo these clips that prising with a screwdriver as I have broken two already and have not released any :rolls:
Cheers Alan
Re: How to split Bosch tub ?
To split this tub you need to cut off the clips and then screw it back together. If I remember right when you order a new seal you get the extra screws with it.
Re: How to split Bosch tub ?
I think officially you are supposed to change the tub half, however someone on here bangs on about using a few sets of steak knives!
Re: How to split Bosch tub ?
Ok cheers for you reply’s think I’ll try and ease them out as much as poss
Re: Re: How to split Bosch tub ?
eastlmark wrote:however someone on here bangs on about using a few sets of steak knives!
That’s Mike Mark and he’s happy with that method. But Bazza is spot on, cut off the tabs with side cutters and you’re all set 😉
Re: How to split Bosch tub ?
Hi
If you order the correct bearing kit it comes with instructions and shows the use of side cutters/snips to cut tabs.
Mike
- You must be logged in to reply to this topic.