Indesit ISL70C fault code

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Indesit ISL70C fault code

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • April 22, 2012 at 6:14 pm #69075
    blackpoolfox
    Participant

    Drier is turning on normally then after about 20 secs gives a beep, momentarily stops then starts running again with the power light flashing rapidly and the following lights blinking around once per sec – from left : time delay, alarm and empty water. The only light not flashing is the high heat light. If the drier is left to run in this state it continues to run but doesnt appear to get warm.

    Any assistance appreciated, thanks.

    April 22, 2012 at 6:53 pm #373625
    iadom
    Moderator

    Re: Indesit ISL70C fault code

    Always best to give the flashing lights by number from top to bottom or left to right.

    Your error message is F13

    Rear NTC open or short circuit.

    April 22, 2012 at 7:25 pm #373626
    blackpoolfox
    Participant

    Re: Indesit ISL70C fault code

    Ok from left – 1,2,4 are flashing once/sec and power light flashing rapidly.

    Ok thanks any idea what kind of a job it is to fix this?

    Many thanks.

    April 22, 2012 at 7:35 pm #373627
    blackpoolfox
    Participant

    Re: Indesit ISL70C fault code

    Could you please also advise where this part is located inside the drier?

    Thanks.

    April 22, 2012 at 7:54 pm #373628
    iadom
    Moderator

    Indesit ISL70C fault code

    iadom wrote:

    Rear NTC open or short circuit.

    Err, at the rear, behind the small back panel.

    The thermostats and NTC should be changed as a complete kit, two different types, one with a white NTC and one black.
    I would also remove the condensor from the bottom of the machine at the front. This should be cleaned out every week or so, if it is badly clogged up then that will lead to stat/ntc failure.

    Be sure to remove the mains plug before removing any panels.

    Sent from my iPad using Tapatalk HD

    April 23, 2012 at 7:46 pm #373629
    blackpoolfox
    Participant

    Re: Indesit ISL70C fault code

    Ok we have taken the back off today, the 2 outer devices are black and the center one is white.
    What would I actually be asking for as a replacement would it be called a rear NTC kit?
    Also, are the 2 outer black devices the same, ie : does it matter which way around they go?

    Many thanks.

    April 23, 2012 at 9:12 pm #373630
    iadom
    Moderator

    Re: Indesit ISL70C fault code

    The thermostat kits come complete, they must be replaced in exactly the same position as the original ones.

    If your serial number is 51130.0000 or less you need C00208298 HERE
    If the serial number is 51130.0001 or higher you need kit C00208299.HERE

    April 24, 2012 at 8:21 pm #373631
    blackpoolfox
    Participant

    Re: Indesit ISL70C fault code

    Fitted replacement parts today and seems to have cleared the fault, many thanks for the info!

    April 24, 2012 at 8:47 pm #373632
    iadom
    Moderator

    Re: Indesit ISL70C fault code

    8)

    And if you are a Seasiders fan you are in the play offs as well. RESULT.

    April 27, 2012 at 5:04 pm #373633
    blackpoolfox
    Participant

    Re: Indesit ISL70C fault code

    Yeah indeed! good result 8)

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.