- This topic has 3 replies, 2 voices, and was last updated 13 years, 11 months ago by
.
-
Posts
-
Looking for a bit of help and advice.
The dishwasher is around 6 years old and following some unusual noises on it’s last wash the machine did not empty the water.
There are no blockages of the filters or the waste pipe so I bought a new Waste pump (Pt No. 483054) with a view to fitting it. I have dismantled the machine to the stage that I can see the waste pump under the L/h sidepanel (if looking at from the machines door).
But, without removing a lot of stuff from the machine and perhaps ‘lifting’ the main body off the base is there a way to change the pump?
Assuming I have to remove a lot of bits from the machine are there any on line guides or handy advice before I have a go?
thanks Jez
Siemens SF24T250GB/18 Waste Pump Change
It fits easily from the front having first removed outer door panel and bottom panel.
Re: Siemens SF24T250GB/18 Waste Pump Change
Martin,
Thanks for the advice I’ll have another go tonight.
I had removed the screws from the bottom panel but not the door skin.
Jez
Re: Siemens SF24T250GB/18 Waste Pump Change
Martin,
Machine now up and running. 😀 😀 😀
Putting the outlet pipe onto the pump was a bit of a pain with the restricted access but managed it in the end.
Old pump appeared to have consumed itself (white rubber seal/gasket jamming the impeller wheel)
Thanks for the advice
Jez
- You must be logged in to reply to this topic.