- This topic has 4 replies, 2 voices, and was last updated 13 years, 10 months ago by
.
-
Posts
-
Hey all, have one of these with what was an e15 fault, water in the base I believe, and so there was.
Drained it and cleared the pump coz she said it also had e25 flashing up on occasion.
It worked for a couple of weeks and now it has an e09 fault, which by searching here appears to be a heat pump/board fault.
My question is how do I know which is gone?
Took PCB out and no obvious damage and I took out the heat pump, the element part of which has 7 wires. First 3 have continuity, as do the last 4. I’ve not seen this type of heater/motor set up at all before so I’m not sure of any values or how I check which is gone before I order a part.
The heat pump is not overly expensive so she may go ahead with e fix, but I’d like to know I’m ordering the right part.Cheers
DaveRe: Siemens D/W SN5M830GB/02
dave-m wrote: I’ve not seen this type of heater/motor set up at all before so I’m not sure of any values or how I check which is gone before I order a part.
Give me your email details and I’ll send you the manual. 😀
- You must be logged in to reply to this topic.