SERVIS M6815W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › SERVIS M6815W

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 11, 2012 at 9:28 pm #69897
    gadgetdad
    Participant

    Hi all, visited one of these units today, owner said it tripped the breaker – not rcd last week and will now only fill.

    Stripped motor off and one brush was badly worn and a lot of carbon on motor, blew motor off and replaced brushes but no drum movement still.

    It does make a dull thud when the start button is pressed before it fills – also if set to spin/drain cycle the drain pump only runs for about 10 seconds. Module looks ok as far as I can see, no obvious flashes etc.

    Any ideas ?

    cheers.

    June 12, 2012 at 7:12 am #376386
    suedehead1
    Participant

    Re: SERVIS M6815W

    the motor has a built in toc which can go open circuit,
    if you have metered the motor you will be able to check it.
    if not its the pcb.

    June 12, 2012 at 7:56 am #376387
    gadgetdad
    Participant

    Re: SERVIS M6815W

    Ho, thanks for the reply – how do I check the motor – never tried to fault find one with a toc before – cheers.

    June 12, 2012 at 6:38 pm #376388
    suedehead1
    Participant

    Re: SERVIS M6815W

    when you check the motor plug there will be 2 wires which do not have a reading between them and any other wires these 2 wires go to the toc if all wires have a reading then the toc is ok its normally 2 wires in the middle of the plug nos 4 and 5.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.