- This topic has 8 replies, 4 voices, and was last updated 13 years, 9 months ago by
.
-
Posts
-
I’ve just ordered a module for the above and have been told by Qualtex that an eeprom will also be required. This module is located behind the facia not at the bottom of the m/c where they usually reside and I cannot see a plug in point for a smart card reader etc.Can some kind soul advise if a eeprom is required, or if it’s a plug in and play type ?
Allan.
Re: Indesit WIA 121UK module
Sorry should have said, the pt no for the module I’ve ordered is : C00143067.
Allan.
Re: Indesit WIA 121UK module
Sorry, should have searched :rolls: apparently it does require a plug in eeprom.
Allan.Re: Indesit WIA 121UK module
allan73 wrote:Sorry, should have searched :rolls: apparently it does require a plug in eeprom.
Allan.EMW be the way for all issues Indesit modules and eeproms. 😉
Re: Indesit WIA 121UK module
Might just do that Martin 😉 but out of interest, I’m assuming that a smart card is not required to programme these should I get an eeprom from Qualtex ?
Re: Indesit WIA 121UK module
you may be lucky and the eeprom might be available, if not you use a blank one and programme it with the smartcard reader/writer with the low end adaptor attached.
Bob.
Re: Indesit WIA 121UK module
If the eeprom is a plugin one then see if the one on the old board is good, as that will already be programmed.
George
Re: Indesit WIA 121UK module
I will need to check if the old eeprom is surface mounted or a plug in type Allsorts. It’s in a holiday cottage and I’m having difficulty getting access at the moment. The m/c’s hardly been used, most people staying there take the washing home with them.
Thanks for the input.
Allan.
- You must be logged in to reply to this topic.