Hotpoint BFI620

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #70436
    ray.t
    Participant

    Hi, Been to one of these today that the lower spray arm had come off and caused the base to flood. I sorted the spray arm and drained the water from the base.
    I then tried to run it through to check all was ok.
    I put it on an eco wash and the machine filled as normal and started to wash but a min or so into the wash it pumped the water out and stopped with the 2nd light lit but not flashing.
    Cheers,
    Ray

    #378076
    A1engineer
    Participant

    Re: Hotpoint BFI620

    the water in base has probably caused an insulation fault on motor or heater.

    kev

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.