Smeg DWF614ss with no fault code

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Smeg DWF614ss with no fault code

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 17, 2012 at 8:13 pm #70519
    jmh69
    Participant

    Hi all
    I’ve got a Smeg DWF614 that has a couple of faults. 1st is that it works fine on the rinse programme but on all the others it runs through the programme ok until it gets to 2 mins from the end then it goes to 5 minutes and continues until you switch it off. Also when the water doesn’t heat up yet there is continuity across the heater terminals.

    Anyone with any ideas please?

    December 3, 2017 at 7:58 pm #378281
    mdaservices
    Participant

    Re: Smeg DWF614ss with no fault code

    Hi IT COULD BE A DRY JOINT ON THE PC BOARD THIS WOULD ACCOUNT FOR A INTERMITTANT FAULT WITH HEATER.
    REGARDS Malcolm

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.