Hotpoint WMD940 Rinceing Twice

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint WMD940 Rinceing Twice

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 25, 2012 at 5:17 pm #70648
    monkeyape
    Participant

    Hello We have Wmd940 I’ve cleaned the filter got 80p from it.
    Did the usaul un plugging from the mains
    Checked the pressure switch blowing in it twice to see if clicks it does.
    The machnie spins twice it looks lkie timer problem has soon it gets to 000.1 then adds 0030 mins again to rince.
    Could it be the PCB control board ?
    thx for help

    July 26, 2012 at 5:29 pm #378602
    the q spark
    Participant

    Re: Hotpoint WMD940 Rinceing Twice

    Hi there, Coins in the pump wont usually cause this problem. it sound like the taco is open circuit this is a small coil located on the end of the motor that put simply, sends signals to the module to regulate the speed of the motor. check the wires as they come out of the taco and as they enter and exit the motor plug then on to the module the wires can break any where so a continuity tester would come in handy but usually the break is quite obvious “Q”

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.