- This topic has 3 replies, 2 voices, and was last updated 13 years, 8 months ago by
.
-
Posts
-
Hi,
I have a new failure on my Whirlpool ADG9540 DishWasher.
When a program is selected, with start on or off, the exit pump is running all the time and no water is coming into the DishWasher.
The Dishwasher has been working normally and then Salt was added, next time wash started the exit pump started and now it runs all the time.
I have cleaned and checked float valve switch and pressure switch, both ok.
There is no water in the bottom and there is no water entering the Dishwasher.
On two occasions the water started coming in after stripping down and refitting, but this stopped after a few seconds.
The Electronics looks ok and does not look burnt
Hope someone can help me please as dishwasher is now 15 years old and not ready to be removed.
cheers
Neil
Re: Whirlpool ADG9540 Exit pump on all the time and no water
is it coming up with a fault code
count flashes on start light
is float switch in base operating ok ?
Dave
Re: Whirlpool ADG9540 Exit pump on all the time and no water
Float switch is operating ok, checked with a multimeter.
I have no fault codes, no flashing I press the button and the light comes on and then press and hold and the light goes off. But no flashing.
Any ideas would be excellent please
It is the pump running all the time that is confusing me, and not water comes into the unit when I select a program.
cheers
Neil
- You must be logged in to reply to this topic.