drum removal from candy csn62t model

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › drum removal from candy csn62t model

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 15, 2012 at 9:08 am #71511
    Chris T
    Participant

    Hi,

    I’ve been trying to remove the drum from the outer casing by punching the spindle with a rubber hammer but without any luck.Any ideas on how to best remove it.Thanks. ❓

    September 15, 2012 at 10:07 am #381320
    kwatt
    Keymaster

    Re: drum removal from candy csn62t model

    Put the nut back on the shaft so as to protect it, leave it sitting slightly proud of the end of the drum shaft. After that it’s brute force and ignorance, up to a point as well as luck in that it doesn’t get damaged.

    K.

    September 16, 2012 at 7:32 am #381321
    Chris T
    Participant

    Re: drum removal from candy csn62t model

    Thanks kwatt,you’re right,the drum spindle needed a good bashing to get it loose,but so did the inner and outer bearings!!!How on earth do I put the new ones in, without damaging them 😕 How about greasing or do I need a specialist tool?

    September 16, 2012 at 10:03 am #381322
    Muv
    Participant

    Re: drum removal from candy csn62t model

    I’d check out the videos on bearing changes on YouTube…it’s a lot easier than explaining it in detail..

    Let us all know how you get on

    Martin

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.