Liebherr KTPES 1750 F2 Fault

Home › Forums › Public Support Forums › Help And Support › Fridge And Freezer Forum › Liebherr KTPES 1750 F2 Fault

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 25, 2012 at 3:26 pm #71658
    l4wrence
    Participant

    Hi,

    I have the following Liebherr table top fridge model:

    Model No. KTPES 1750 INDEX 20E
    Service No. 9986817-05
    Appliance No. 42.851.898.9

    The display is showing an F2 fault code and I have had an engineer (booked through this website) visit today to take a look. Although from my searching this appears to be an evaporator sensor fault code the engineer has said he can’t find any sensor on this model and that I will need a new PCB.

    Does this sound correct? I just don’t want to spend £s if the new PCB doesn’t fix the issue and I assume a new PCB is more expensive than a new 9590142 Air Sensor kit!

    September 25, 2012 at 3:35 pm #381845
    qcarelsen
    Participant

    Re: Liebherr KTPES 1750 F2 Fault

    Hi there, I am on this case for you, so don’t worry about it, as soon as I get this sorted I will give you a call.

    September 25, 2012 at 3:39 pm #381846
    kwatt
    Keymaster

    Re: Liebherr KTPES 1750 F2 Fault

    There is indeed a sensor and, the very part number that you have identified.

    To be fair it isn’t exactly obvious though.

    Shown as 180 in the attached.

    K.

    September 25, 2012 at 3:53 pm #381847
    l4wrence
    Participant

    Re: Liebherr KTPES 1750 F2 Fault

    Thanks guys. It’s typical when you’re on a tight budget some appliance or car part has a habbit of going wrong! I was under the impression Liebherr was a quality make (it certainly cost a small fortune) but this problem is only after 3.5 years of operation.

    September 25, 2012 at 3:56 pm #381848
    kwatt
    Keymaster

    Re: Liebherr KTPES 1750 F2 Fault

    To be fair, I suspect that’s more bad luck than anything else as Liebherr stuff is very, very good.

    K.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.