indesit di450 fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › indesit di450 fault

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 18, 2012 at 10:30 pm #72036
    SPBAIN
    Participant

    hi

    i had a problem that the heater was not heating the water so i replaced the relay on the pcb with one from maplins JM67X. since i have replaced the relay when i start the dishwasher after about 1 minute the solonoid on the dispenser clicks to open the flap then keeps on clicking for about 2 minutes. shoud i have replaced something else with the relay.

    thanks

    October 21, 2012 at 8:05 am #383166
    bryan-206
    Participant

    Re: indesit di450 fault

    The PCb……?

    October 21, 2012 at 8:07 am #383167
    bryan-206
    Participant

    Re: indesit di450 fault

    Are you certain you replaced the correct relay? Also what led you to replace the relay?

    October 21, 2012 at 10:06 am #383168
    Allsorts
    Participant

    Re: indesit di450 fault

    Also, you would need to ensure that you replaced the relay with an equivilant.. ie gates and switches need to be the same.

    October 21, 2012 at 10:40 pm #383169
    SPBAIN
    Participant

    Re: indesit di450 fault

    i had the leds flashing on the panel after i did some research on what the fault was it said faulty relay or element. i tested the element to be ok and someone listed on this site that relay JM67X from maplins.co.uk is the same.i have not got the original to compare it with anymore.

    do you think it is control pcb or dispenser solenoid that is faulty?

    thanks

    November 1, 2012 at 7:26 am #383170
    bryan-206
    Participant

    Re: indesit di450 fault

    PCb… Dispenser requires power to click. Power is only supplied for seconds to release the flap. Or should be anyway.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.