- This topic has 2 replies, 3 voices, and was last updated 13 years, 4 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Visited this machine and found it was stuck during the rinse. Not everytime but happens every now and then. Checked water fill ok, insulation ok, brushes ok, drain and motor action ok, timer seems to progress ok.
Timer circuit board looks clean, no signs of blowing. Can’t think of anything which caused the rinse to stop and yes the “rinse” hold button is not activated.
Any ideas?
Re: Hotpoint WD64 stuck in rinse
Faulty rinse hold switch?
Heater relay contacts welded closed
Sump filter blocked..Martin
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.