Dishwasher leg pressing against gas pipe

Home Forums General Trade Forum Dishwasher leg pressing against gas pipe

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #72737
    twicknix
    Participant

    Should I be concerned? Don’t know why the kitchen fitter did this? The gas pipe is for the double oven next the dishwasher.

    #385434
    DrDill
    Participant

    Re: Dishwasher leg pressing against gas pipe

    Wow, theres a lot going on under there, i would be horrified if my fitter did a job like that. Might not break any code but could have been done a whole lot better and normally when you do it better it tends to be safer.


    Sent from my iPhone
    http://www.kitchenkitsw.com

    #385435
    twicknix
    Participant

    Re: Dishwasher leg pressing against gas pipe

    It took me a long pause on how to remove the dishwasher.

    The pipe was very rigid and the leg did not push it which was kind of a relief but I was not very happy with the workmanship. It puts me in a compromising position. I am not a gas fitter but I can see it was badly designed and ill thought which could have been done better.

    Putting the dishwasher back is another matter. Don’t know how they did it in the first place (bruce force springs to mind).

    #385436
    DrDill
    Participant

    Re: Dishwasher leg pressing against gas pipe

    Looking at it i think i would make a platform for it to sit on, the legs are for levelling and should not be wound down that far anyway, 2 pieces of worktop with the top one longer and it will go over the gas pipe, the cables just need sorting then!


    Sent from my iPhone
    http://www.kitchenkitsw.com

    #385437
    lee8
    Participant

    Re: Dishwasher leg pressing against gas pipe

    Are you sure its a gas pipe, I cannot see any PVC tape or other protective pipe.

    If its laid above the base concrete covered in screed it should have double thickness PVC around the pipe, usually some is visible as the pipe comes out.

    If its laid in solid floor it has to be placed through plastic tube or preformed duct.

    I’d be more concerned with that, the leg is not going to exert enough force in that position to damage it.

    #385438
    twicknix
    Participant

    Re: Dishwasher leg pressing against gas pipe

    yes lee8, it is gas pipe as I traced it to the oven. It’s copper pipe with soldered on elbow joint. The floor is wooden.

    #385439
    Madmac
    Participant

    Re: Dishwasher leg pressing against gas pipe

    twicknix wrote:

    Putting the dishwasher back is another matter. Don’t know how they did it in the first place (bruce force springs to mind).


    Is that an Australian superhero one can call on to shift stubborn integrated appliances? 😉

    Must admit I would be concerned by that foot pushing the gas pipe too, but then I’m totally paranoid when it comes to gas.

    It probablywont cause any issues whatsoever but whos to say several years of slamming the dishwashers door and baskets wont jiggle the pipe a bit?

    I would prefer to see it raised on a decent bit of wood I must say. 😯


    Eddie.

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.