- This topic has 5 replies, 2 voices, and was last updated 13 years, 3 months ago by
.
-
Posts
-
The dryer will run anti clockwise for say 20 seconds and both elements come on. there is a click and the dryer then goes clockwise and the elements remain off for every cycle
Thanks
Zen
Re: BEKO DRVS 73 W HEATING ELEMENTS CUT OUT
zenithtime wrote: the elements remain off for every cycle
Thanks
Zen
Sensor bar fault should’nt effect all programs, only the sensor dry ones, it should work on timed drying o.k even with a faulty sensor bar.
Re: BEKO DRVS 73 W HEATING ELEMENTS CUT OUT
thanks for getting back to me, it is still playing up, i have changes the elements , cleaned about everything i can, still not getting hot help !!!!!!!!!!
Re: BEKO DRVS 73 W HEATING ELEMENTS CUT OUT
Theres a low temperature switch on the front, make sure its not selected, e/g lit, if it was selected dryer runs only on 1/2 heat.
N.T.C controls heating during drying with sensor under door switching off when degree of dryness is achieved.
Problems with poor heating could be attributed to blocked fan, blocked ducting or filters, or even on the outlet grill on outside of wall where vented air exhausts.
P.C.B could be at fault but this should be last resort to change.
- You must be logged in to reply to this topic.