miele w526

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › miele w526

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 22, 2013 at 6:16 pm #73703
    HotDog
    Participant

    Not been to this yet but customer says rinse light starts to flash shortly after starting to wash looked in known error codes but no match anyone have any ideas on this

    January 22, 2013 at 8:01 pm #388530
    Seamy
    Participant

    Re: miele w526

    Rinse led flashing indicates no motor action. Check brushes.

    January 22, 2013 at 8:35 pm #388531
    HotDog
    Participant

    Re: miele w526

    Yes thanks for that i did find it after the post sounds like you have to remove the front panel to access the motor

    January 23, 2013 at 8:25 am #388532
    Muv
    Participant

    Re: miele w526

    If its not the brushes… Its board out time and replace a few components..ive done around 10 of them in the last 2 months…

    If you want you can send me the board?

    Martin

    January 23, 2013 at 8:27 am #388533
    Muv
    Participant

    Re: miele w526

    As long as its fitted with the EL200 board of course!

    January 23, 2013 at 9:00 am #388534
    Muv
    Participant

    Re: miele w526

    Just checked ..its fitted with the EDPL122 board… Sorry dont repair those…yet!

    Martin

    January 23, 2013 at 7:14 pm #388535
    Seamy
    Participant

    Re: miele w526

    Rinse led flashing means no motor action, i’d start by checking the motor brushes, back plate that houses brushes comes off motor.
    If the motor is o.k & loom/connections are o.k then i’d think about getting a p.c.b.
    There should be a schematic diagram in all Miele appliances that will allow you to check/trace cabling from p.c.b to motor.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.