Beko WM5100 No spin

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WM5100 No spin

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 31, 2013 at 2:58 pm #73879
    Muv
    Participant

    Hi guys

    Just been to the above machine, with no spin fault..

    Brushes and tacho checked out fine,so ran the self test mode
    On this the spin works fine! as does everything else!

    Am i right in thinking that the self test does not use the voltage from the tacho, and therefore it will spin on self test?

    Am goin back tommorow to try a new tacho, before replacing the board i guess.

    The only thing i didnt check were the wires goin up to the board from the tacho connections on the motor connector

    Any ideas welcome?


    Martin

    January 31, 2013 at 6:12 pm #389171
    Seamy
    Participant

    Re: Beko WM5100 No spin

    When you say no spin, do you mean it washes but doesn’t spin?
    Unbalanced load is the main reason for no spin i’m sure you are aware of this.
    Have had problems with poor contact of the brushes on Beko motors, may be an idea to change brushes & use comm stick.
    Also have seen them go to full spin immediately with tacho faults rather than no spin.

    January 31, 2013 at 6:22 pm #389172
    Muv
    Participant

    Re: Beko WM5100 No spin

    Yes washes fine , just no spin..customer didnt have enough clothes for me to try a full load..
    Cleaned the comm up, but still the same

    Have heard that these machines wont spin at all if empty?
    And also As mentioned in my first posting, it spins during a self test, no problems

    Martin

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.