Indesit dif 04 dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit dif 04 dishwasher

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • February 18, 2013 at 7:44 pm #74197
    ddirect
    Participant

    Indesit dif 04 dishwasher
    Does compulsory drain, fills, then stops with
    Light 1-2-3 flashing
    Any ideas
    Darren

    February 18, 2013 at 9:01 pm #390416
    iadom
    Moderator

    Re: Indesit dif 04 dishwasher

    ddirect wrote:
    Any ideas

    Read the Known Error codes thread, it’s been in there for almost two years. 😉

    February 18, 2013 at 9:21 pm #390417
    ddirect
    Participant

    Re: Indesit dif 04 dishwasher

    Read it checked wiring changed wash pump still have same problem,thats why i put this post up to see if there where any other answers to this problem. Thanks for looking.

    February 18, 2013 at 9:52 pm #390418
    iadom
    Moderator

    Re: Indesit dif 04 dishwasher

    ddirect wrote:Read it checked wiring changed wash pump still have same problem,thats why i put this post up to see if there where any other answers to this problem. Thanks for looking.

    Changed pump? According to the known error codes 1-2-3 is a water turbine (impellor) fault. 😕
    error codes

    February 18, 2013 at 10:15 pm #390419
    madangler1
    Participant

    Re: Indesit dif 04 dishwasher

    Likely board as Iv seen the water turbine fault a few times before and was the board.

    February 19, 2013 at 7:59 am #390420
    ddirect
    Participant

    Re: Indesit dif 04 dishwasher

    Iadom to my knowledge is a water turbine impeller just another name for a wash pump or part of it?
    Thanks madangler1,

    February 19, 2013 at 8:59 am #390421
    iadom
    Moderator

    Re: Indesit dif 04 dishwasher

    No, the water turbine, which is known as an impellor jug on Bosch machines and is used on several makes. It seems to cause most problems on Bosch and Whirlpool from my experience. I have seen them in BSH washing machines as well as the large Whirlpool washers.

    It is literally a small turbine situated just after the inlet valve, as the water enters it turns and generates a signal to the pcb to control the amount of water and monitor the flow.

    On the Bosch machines it is a separate part but on the Indesit/Hotpoint and also the Whirlpool it is built into the plastic, water inlet chamber.

    THIS is the common Hotpoint/Indesit one that fits your model. You can see the small turbine, bottom right in that picture.

    February 19, 2013 at 6:26 pm #390422
    ddirect
    Participant

    Re: Indesit dif 04 dishwasher

    Thanks iadom didnt notice it i know what your on about ive relpaced them before, but to be honest i never noticed it having seen it has a pressure switch i never looked.
    ill call back tomorrow and once again thanks.
    Darren

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.