Hotpoint WD860 stops on 1 minute remaining

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint WD860 stops on 1 minute remaining

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 21, 2013 at 7:59 pm #74259
    hughwatkins
    Participant

    Hi,

    I’ve got a Hotpoint WD860 washing machine. On all cycles it runs fine, then stops on 1 min for ever. You have to cancel the cycle then rinse & spin.

    Any ideas what the fault could be? No lights or warning messages.

    Thanks

    Hugh

    February 21, 2013 at 10:35 pm #390608
    iadom
    Moderator

    Re: Hotpoint WD860 stops on 1 minute remaining

    Sadly there is no specific answer to your question, the Indesit electronics in this machine are very flaky at the best of times.

    It could be just about anything from faulty pressure switch, drain pump, main pcb, dryer ntc, bad insulation etc, etc.

    It can be a nightmare to isolate the cause and an expensive one at that. 😥

    February 21, 2013 at 10:40 pm #390609
    scientist
    Participant

    Re: Hotpoint WD860 stops on 1 minute remaining

    Whats the water pressure like? Had this on a hotpoint recently and this is what the fault was! Best of luck 🙂

    February 24, 2013 at 9:47 am #390610
    karv
    Participant

    Re: Hotpoint WD860 stops on 1 minute remaining

    Have you checked the waste pipe is not to far down the down pipe if you have one .
    I had a element causing problems once can,t recall if was open circuit or low insulation.

    February 24, 2013 at 10:31 am #390611
    iadom
    Moderator

    Re: Hotpoint WD860 stops on 1 minute remaining

    You will see from the last two posts that there is no definitive answer to your question, only three or four more possibilities. 😥

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.