ise 5-2

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ise 5-2

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • March 1, 2013 at 12:15 pm #74383
    alfie
    Participant

    My first call to one of these. It has an E10 fault.
    Fills, empties but no wash or spin. Suspect motor problem.
    I cant find A manual for this machine with digital display and induction motor. Is there one?

    Read some posts re inverter cards. Is this the module fitted in base at front? could this be the cause of my problem?

    Thanks in advance

    March 1, 2013 at 12:26 pm #391301
    kwatt
    Keymaster

    Re: ise 5-2

    Yes, motor or inverter card will be the likely cause or, the wiring in between.

    K.

    March 1, 2013 at 2:04 pm #391302
    alfie
    Participant

    Re: ise 5-2

    cant find A repair manual for this machine with digital display and induction motor. Is there one?

    March 1, 2013 at 2:11 pm #391303
    kwatt
    Keymaster

    Re: ise 5-2

    Yup, in the stickies at the top of this forum.

    K.

    March 1, 2013 at 6:20 pm #391304
    alfie
    Participant

    Re: ise 5-2

    This is the only one I can find.
    Servicing & diagnostics guide Version 1.0 – December 2008.
    Not applicable to my machine . Is there another version?

    March 1, 2013 at 6:23 pm #391305
    kwatt
    Keymaster

    Re: ise 5-2

    ise-trade-support/ise5-technical-documentation-washer-t39521.html

    Bottom two.

    K.

    March 1, 2013 at 8:35 pm #391306
    alfie
    Participant

    Re: ise 5-2

    Cant see a E10 fault of inverter card,induction motor in that manual

    March 1, 2013 at 8:40 pm #391307
    kwatt
    Keymaster

    Re: ise 5-2

    Possibly not but it has been discussed at length many times. I can’t even recall if it was in the original manual TBH.

    K.

    March 1, 2013 at 9:39 pm #391308
    iadom
    Moderator

    Re: ise 5-2

    AFAIK E10 is not a recognised error code. E08 is motor fault.
    Although there is THIS

    March 1, 2013 at 11:54 pm #391309
    aqualectric
    Participant

    Re: ise 5-2

    Had a couple of E10’s….

    Wiring, solder joint on inverter card, faulty inverter card ….in that order.

    Steve.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.