indesit idl 535!

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › indesit idl 535!

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • March 12, 2013 at 6:41 pm #74524
    ajkwales
    Participant

    Hiya

    I have unfoutunatley got an indesit idl 535 dishwasher.
    Went to take the dishes out as i thought it had finished
    but it was still dirty water in it..
    There are no light flashing at all but i cant reset it
    either, tried turning it off for a few hours but still
    wont do amything..
    Any ideas please

    thanks

    March 12, 2013 at 6:45 pm #391899
    iadom
    Moderator

    Re: indesit idl 535!

    Are any lights showing when you switch it on and off?

    March 12, 2013 at 8:52 pm #391900
    ajkwales
    Participant

    Re: indesit idl 535!

    No the only light that shows at all is the
    red power light!

    March 12, 2013 at 9:04 pm #391901
    iadom
    Moderator

    Re: indesit idl 535!

    So there is a light showing then. Could be a main pcb failure. 🙁


    Sent from my iPad using Tapatalk HD

    March 12, 2013 at 11:35 pm #391902
    ajkwales
    Participant

    Re: indesit idl 535!

    how would i know, and would it be worth repairing?

    thanks again

    March 13, 2013 at 8:45 am #391903
    iadom
    Moderator

    Re: indesit idl 535!

    You would have to isolate from the mains and open it up. Then you would need proper test equipment to check that there is a supply to the main pcb and also visually check the wiring inside the door, it can break where it bends at the bottom.

    It could be a faulty door latch or switch.

    March 13, 2013 at 3:32 pm #391904
    fasetester
    Participant

    Re: indesit idl 535!

    make sure to switch of power :plug: before you check or remove any panels could be a blockage in the pump fasetester

    March 13, 2013 at 3:52 pm #391905
    iadom
    Moderator

    Re: indesit idl 535!

    iadom wrote:You would have to isolate from the mains

    I think I might have mentioned that fasetester :rolls: also a simple pump blockage would give flashing error messages, it would not leave the machine dead with just the mains indicator light on.

    March 15, 2013 at 3:20 pm #391906
    fasetester
    Participant

    Re: indesit idl 535!

    sorry jim for stepping on your toes 😉 fasetester

    March 15, 2013 at 3:26 pm #391907
    iadom
    Moderator

    Re: indesit idl 535!

    fasetester wrote:sorry jim for stepping on your toes 😉 fasetester

    No problem, I always wear steel toe caps. :mrgreen:

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.