- This topic has 2 replies, 2 voices, and was last updated 12 years, 11 months ago by
.
-
Posts
-
Pnc:914002586-00
Set to any programme and after a couple of seconds the mains light flashes/beeps five times then repeats.
It will not go into diagnostics mode, still does the same five flashes.
Got the megger out and found dead short on main motor. 😥
Plugged in with motor unplugged and could then select programmes and it would fill and drain, but could still not get it into diagnostics mode.
The cost of a new motor alone is going to BER this machine, just wondered if the motor fault may have damaged the main pcb as well?
Jim.
Re: AEG 5 beeps
Should go into diagnstics, you sure you’ve done it correctly. It will show a motor fault if the motor is disconnected, the motor normally wouldn’t have done damage to p.c.b, but if you have a peep at it you can normaly see if theres burn marks etc on board.
- You must be logged in to reply to this topic.