Zanussi ZWD12270W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWD12270W

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 2, 2013 at 6:36 am #76070
    WhiteVanMan1
    Participant

    The machine pumps out for a few seconds, then starts to fill for a few seconds on all wash programmes. It then stops dead and unlocks the door? There is no fault code, and I have checked the pump for debris, and the brushes are in almost brand new condition. I can’t see anything obviously wrong. The fault has been occurring on and off for a few weeks, but has always corrected itself up until now. Intermittent faults! When I set the dryer working, it works perfectly. Any help or thoughts would be greatly appreciated. Cheers. Steve.

    July 2, 2013 at 8:05 am #397135
    Criscold
    Participant

    Re: Zanussi ZWD12270W

    Have you meggered the dryer heater as these throw up some strange faults on these, I normally disconnect the wires and then test machine. Can you get into diagnostics ?

    July 2, 2013 at 10:22 am #397136
    WhiteVanMan1
    Participant

    Re: Zanussi ZWD12270W

    Thank you Criscold. Damn! I can’t believe I didn’t check that as I have come across it before. I’ll put it down to a mental block lol. I’ll check it out and let you know. I can get into diagnostics, but the display is all over the place. That would tie in with a faulty dryer heater. Thank again. Steve.

    July 2, 2013 at 10:59 pm #397137
    leavemetogetonwithit
    Participant

    Re: Zanussi ZWD12270W

    If it isn’t that, I’d megger the motor on its own or disconnect it and try. It sounds like it stops at the moment when the motor kicks in.
    What happens when you try it on spin?
    Mike.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.