fault code EFO AEG 16830

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › fault code EFO AEG 16830

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 5, 2013 at 7:50 pm #76546
    SteveKLX
    Participant

    My Washer dryer displays the code EFO.I have stripped the machine down and cleaned all hoses, pumps and filter. The code suggests a leak, however there is no evidence of one. The remedy suggested for resetting the error code is to drain the water away from the anti flood device and as a result of doing so, the code will automatically reset. I have also tried pressing and holding the 2 far left buttons and turning the control dial 2 clicks.(it suggested 1 click but info from another forum suggested 2) then a further 9 clicks, back to off, back on, then off. This also did not work.
    Please if any one can assist I would be very very grateful.
    Thank you
    Steve

    August 6, 2013 at 10:27 am #398739
    electrofix
    Moderator

    Re: fault code EFO AEG 16830

    not all EF codes will reset this way
    there is 1 EF4 that need resetting by an engineer who can then check the machine for a fault

    as a user you will get the code EF0 but if you went into the engineering mode you will get EF1, 2 ,3 or 4

    EF4 Water fill pressure too low , no signal from flow meter and solenoid valve open

    This machine counts the water in with a flow meter same as petrol pumps do. if this meter is not working and the timer expects it too it will lock out to prevent flooding

    August 6, 2013 at 9:25 pm #398740
    SteveKLX
    Participant

    Re: fault code EFO AEG 16830

    Hi
    Thanks for your time and info on error codes. As much as I hate saying it, Some times you just have to accept defeat. Ive got an engineer calling tomorrow.
    Steve

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.