no power to fill valve

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › no power to fill valve

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 10, 2013 at 9:32 am #77067
    monk1
    Participant

    Hi
    I have a indesit dis04 dish washer everything seems ok but it wont fill I have checked and there is no voltage at the fill valve. Is it the pcb or is there something in the safety circuit that I am missing ( door switch is ok)
    Any help would be appreciated.
    Thanks

    September 11, 2013 at 4:30 pm #400910
    Washdisher
    Participant

    Re: no power to fill valve

    Hi,

    Check for water in the sump which will activate the anti flood device (polystyrene float with a microswitch above it). This would cause the PCB not to initiate filling.

    Check security of fill valve connectors to PCB. You’ll have to trace the wiring from the valve to the PCB.

    Check for voltage where the fill valve block connector attaches to PCB.

    Check that the machine has drained thoroughly. If not, check the outlet for blockages and the drain pump for obstructions, continuity and voltage.

    That should keep you busy for minute or two 😉

    September 11, 2013 at 9:01 pm #400911
    iadom
    Moderator

    Re: no power to fill valve

    Washdisher wrote:

    Check for voltage where the fill valve block connector attaches to PCB.

    Moved to correct forum.

    We do not advise doing any live testing, it is not neccessary.

    September 12, 2013 at 1:22 pm #400912
    Washdisher
    Participant

    Re: no power to fill valve

    iadom

    point taken, sorry

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.