- This topic has 6 replies, 3 voices, and was last updated 12 years, 6 months ago by
.
-
Posts
-
Hi has anyone had a problem with the door seal restraint coming away and is there any way of refitting it
Sent from my iPad using Tapatalk HDRe: Kenwood dishwasher kew60x10
Yes and no – to keep it simple. The tank/general assembly is an old indesit design. If I’m right in my thinking it is made in China by Haier. I have seen loads Indesit/Hotpoint/Haier models where the spot wleds come adrift. Again if I remember correctly, the tank is N/A and non-repairable. We alwways used to BER them but I daresay you may be able to effect a repair using blind (pop) rivets.
Re: Kenwood dishwasher kew60x10
Yep the spot welds have gone. May try riveting cheers, if not they’ll have to get a decent one
Sent from my iPad using Tapatalk HDRe: Kenwood dishwasher kew60x10
Tank available via connect for around £40. Takes around 45 minutes to fit.
Sent from my GT-N7000 using Tapatalk 2
Re: Kenwood dishwasher kew60x10
lee8 wrote:Tank available via connect for around £40. Takes around 45 minutes to fit.
Sent from my GT-N7000 using Tapatalk 2
Thanks ill check. Is it much of a job
Re: Kenwood dishwasher kew60x10
Not really ,sump seal bit tricky. Easier than Bosch.
Sent from my GT-N7000 using Tapatalk 2
- You must be logged in to reply to this topic.