Fischer Paykel Dishwasher 2 Draw

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Fischer Paykel Dishwasher 2 Draw

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 27, 2013 at 3:50 pm #77367
    Taff
    Participant

    This machine starts the cycle, heats up and washers but fails to drain and just stops with water in the draw bottom. There are no error codes emitted. The pump on these machines washes and drains I believe. Has anyone got thoughts on what the fault is. This fault is on the top draw only, the bottom draw works OK. Any information would be appreciated. How is the draw removed to gain access to the circuit board etc?

    September 30, 2013 at 3:32 pm #401975
    electrofix
    Moderator

    Re: Fischer Paykel Dishwasher 2 Draw

    circuit board is behind front cover

    remove 2 side pins ( round 10mm dia with a bar across middle)
    pull out with pliers

    front should pull out and drop off

    cant think why its not draining unless its blocked. they reverse rotor to drain as far as i know


    i would remove filter and rotor and look for blockages. both item unlock by turning and pull out

    Dave

    October 1, 2013 at 11:05 am #401976
    Taff
    Participant

    Re: Fischer Paykel Dishwasher 2 Draw

    Went back to check this machine as it was bugging me. One of the two drain hoses was blocked with fat. Strange how only one was blocked at the Y Connector.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.