Miele t4262c pcb repair

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele t4262c pcb repair

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 9, 2013 at 7:33 pm #77529
    steve1
    Participant

    Hi
    Anyone know who can repair the pcb control board on a miele t4262c dryer.
    As a new pcb is £300, pcb number is Epwl 300a. Miele part number 6190984
    Miele have diagnosed a faulty pcb
    Thanks
    Steve

    October 9, 2013 at 8:55 pm #402448
    admin
    Keymaster

    Re: Miele t4262c pcb repair

    Hi

    What is the fault that you have ? we might be able to have it repaired dependent on the fault.

    Bryan

    October 10, 2013 at 8:21 am #402449
    steve1
    Participant

    Re: Miele t4262c pcb repair

    Hi Bryan
    The dryer works ok on 20 mins warm air but any other setting eg automatic etc it starts up the 20 seconds later it stops and beepsand the finish light comes on

    October 10, 2013 at 10:04 am #402450
    admin
    Keymaster

    Re: Miele t4262c pcb repair

    Hi Steve

    Has this model got the carbon sensor brushes on the op of the drum ? (cant be bothered to look for the manual) 😆

    Have these been changed as these will cause the same problem.

    Bryan

    October 10, 2013 at 4:54 pm #402451
    steve1
    Participant

    Re: Miele t4262c pcb repair

    hi
    yes the carbon brushes are on the top of the drum, no I have not changed them I will try that thanks

    October 11, 2013 at 1:47 pm #402452
    steve1
    Participant

    Re: Miele t4262c pcb repair

    hi
    ordered some sensor carbon brushes,
    the front thermistor is reading 14.4k ohms
    the rear thermistor is 94.4k ohms,the values change when hot or cold

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.