Indesit idv75 bearing problem

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit idv75 bearing problem

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 16, 2013 at 10:36 am #77647
    bmrenr
    Participant

    Hi I have the above dryer I was called to a couple of months ago making an awful noise which turned out to be that the bronze tear shaped bearing was worn and the shaft of the drum had worn its way down through the bearing so I replaced it with a new one. I also checked the bearing pads around the door and they were ok. A couple of months later I have the same prob is there anything I’m missing that is causing this to wear so fast?

    Tom

    October 16, 2013 at 10:53 am #402874
    Andy jones
    Participant

    Re: Indesit idv75 bearing problem

    Replace the pads and felts as well


    Sent from my iPad using Tapatalk HD

    October 16, 2013 at 11:36 am #402875
    bmrenr
    Participant

    Re: Indesit idv75 bearing problem

    Cheers Andy I have done but looking at the m/c going now I can see the shaft is running out so that’s my problem.

    Tom

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.